• Create BookmarkCreate Bookmark
  • Create Note or TagCreate Note or Tag
  • PrintPrint

Using ANSI.SYS

You must place the ANSI.SYS command in the CONFIG.SYS file to load the driver and reboot the system so that the new configuration takes effect, you must issue commands that tell DOS to use the ANSI features.

Because some software is written to use ANSI codes, one or more of your programs might require that ANSI.SYS be loaded. The installation procedure for this type of software notifies you of this requirement. (The program might even install the command in the CONFIG.SYS file for you.)


PREVIEW

                                                                          

Not a subscriber?

Start A Free Trial


  
  • Creative Edge
  • Create BookmarkCreate Bookmark
  • Create Note or TagCreate Note or Tag
  • PrintPrint