• Create BookmarkCreate Bookmark
  • Create Note or TagCreate Note or Tag
  • PrintPrint
Share this Page URL
Help

Chapter 43. Adding Removable Media > Installing an Internal SCSI Removable Medi...

Installing an Internal SCSI Removable Media Drive

Installing an internal SCSI removable media drive is almost exactly the same as installing an internal IDE drive. The cable is a bit different, and just as you do when installing a SCSI hard disk drive, you must set the SCSI ID on the removable media drive according to the instructions that came with your drive. Remember, too, that the SCSI ID of the drive (0–6) has to be unique.

All SCSI devices, such as hard disk drives and removable media drives, leave the factory with a preset SCSI ID, which in most cases you can leave as is. Just be sure to check that the ID set on the device isn't an ID you are already using on your SCSI chain. Two devices on a SCSI chain with the same ID will not operate.



PREVIEW

                                                                          

Not a subscriber?

Start A Free Trial


  
  • Creative Edge
  • Create BookmarkCreate Bookmark
  • Create Note or TagCreate Note or Tag
  • PrintPrint