Share this Page URL
Help

Chapter 5. DeskBeam Bass: > Playing Your Instrument - Pg. 168

Nano Project 5 ideal. Measure and mark the locations for the screw holes and tine slots, and drill or dremel them out. Insert the tines through the slots, screw the multiplier in place with four self- tapping screws, and wire it up. Wiring is simple: run the leads from the retractor mecha- nism in parallel to each side of the circuit on the multiplier and solder them in place. Drill a suitable hole in the side of the box for the cord to pass through, run the cord through it and attach the plug assembly. [Figure N5.03, Figure N5.04] Check your continuity, button up the box, and look for an excuse to go mobile with a corded tool. Marvel at your extreme cleverness.