• Create BookmarkCreate Bookmark
  • Create Note or TagCreate Note or Tag
  • PrintPrint
Share this Page URL
Help

Chapter 5. Remotely Control Your Computer > Exhibit A: Bill of Materials

5.7. Exhibit A: Bill of Materials

You'll need all of the following items if you are going to build your own IR receiver.

Table 5-1.
Item Quantity Part number
Prepunched perfboard, .100" x .100" spacing, 0.042" hole diameter 1 sheet Radio Shack 276-1395 A
38 kHz IR Receiver Module 1 Radio Shack 276-640
4k7 (4.7 kΩ) resistor 1 Radio Shack 271-1124
1N4148 diode 1  
4.7 μF capacitor 1 Radio Shack 272-1024
78L05, 100mA voltage regulator (TO-92 casing) 1 NTE 977
9-pin female D-Sub connector 1 Radio Shack 276-1428
D-Sub connector hood 1 Radio Shack 276-1539
3-conductor cable Variable  



PREVIEW

                                                                          

Not a subscriber?

Start A Free Trial


  
  • Creative Edge
  • Create BookmarkCreate Bookmark
  • Create Note or TagCreate Note or Tag
  • PrintPrint