• Create BookmarkCreate Bookmark
  • Create Note or TagCreate Note or Tag
  • PrintPrint

Bone Up Tags

There’s another control you should know about when setting up a Skelegon structure in Modeler. Bone Up Tags are small controls that most people aren’t aware of. Often, after you create a Skelegon in Modeler and convert it to a bone in Layout, as you’ve done in this chapter, the rotational control is off. For example, support that you begin creating a Skelegon structure in Right view (bottom right). You begin creating a hierarchy, and then you decide to continue the hierarchy in Top view (upper left). Figure 11.63 shows three Skelegons created this way.

Figure 11.63. A Skelegon is drawn in succession in Right view. Then, the second Skelegon is drawn in Top view. This creates a rotation problem in Layout.



PREVIEW

                                                                          

Not a subscriber?

Start A Free Trial


  
  • Creative Edge
  • Create BookmarkCreate Bookmark
  • Create Note or TagCreate Note or Tag
  • PrintPrint